AUTOMATION OF WIRE LENGTH CONTROL IN THE WIRE CUTTING PROCESS

Authors

  • Bobirjon Qurbonov Author

Keywords:

wire cutting, length control, encoder, PLC, servo drive, PID controller, automation, defect reduction

Abstract

This thesis examines the automation of wire length control in the wire cutting process. The shortcomings of conventional manual measurement methods are analyzed, and an automatic control system based on an encoder, PLC, and servo drive is proposed. PID controller parameters were tuned in the MATLAB/Simulink environment and the accuracy of various control methods was compared. Research demonstrates that the proposed system enables wire cutting with ±0.5 mm accuracy, reduces defective output by 8.4 times, and increases production throughput by 2.5 times compared to manual methods.

References

1. Karimov Q.X. Fundamentals of Industrial Automation. – Tashkent: O'qituvchi, 2021. – 256 p.

2. Bolton W. Programmable Logic Controllers. – 7th Edition. Elsevier, 2021. – 380 p.

3. Ogata K. Modern Control Engineering. – 5th Edition. Pearson Education, 2020. – 894 p.

4. Heidenhain GmbH. Rotary Encoders Technical Documentation. – 2023.

5. Siemens AG. SINAMICS V90 Servo Drive System Manual. – Nuremberg: Siemens, 2022.

6. MathWorks. MATLAB/Simulink Control System Toolbox Documentation. – 2023.

7. Axmedov R.R. Automatic Control Systems of Technological Processes. – Tashkent: Fan va texnologiya, 2020. – 312 p.

Indicator

Manual

Z-N PID

C-C PID

Length error (mm)

±8.4

±1.2

±0.5

Cycle time (s/piece)

4.8

2.1

1.9

Defect rate (%)

4.2

0.9

0.5

Throughput (pcs/hour)

750

1580

1890

Published

2026-06-03